Smart Termo

The “Smart Termo” application is another step towards a smart home, the ability to control one or two heaters in a heating system together with an indirect heating boiler. For example, when a gas boiler is included in the heating system, and an electric boiler connected in parallel is used as a backup (in case of a gas shutdown), and an indirect heating boiler is included in the system for hot water supply. The application works in conjunction with a control board that connects to the local network via a WI-FI router, which is an integral part of any modern home (house, apartment, cottage). Maintaining the set temperature and controlling the heater is based on the air temperature.
The boiler is controlled by redirecting the movement of the coolant for the time of heating hot water through the boiler.
The hardware-software complex manages and controls the following parameters:
- air temperature;
- temperature of the heat carrier in the pipes;
- water temperature in the boiler;
- operating mode, taking into account the day and night tariff;
- set temperature;
- status of the heater at the moment (on - off);
- heater operation time for the current day;
- the time of the absence of electricity, if there was a shutdown for the current day;
- information about connection status, current server time.
All telemetry is available in the application, and once a day a report for the current day with hourly monitoring of the listed parameters is sent to the specified email address. In the event of an emergency - the air temperature drops below +3˚С, or the coolant temperature exceeds +95˚С, the device will send an email every 9 minutes. mail an alarm message with the above parameters.