EconTool Nissan/Toyota ELM327

Program for communication with cars Nissan and Toyota.
For Nissan cars, petrol engine control units are supported, which are diagnosed by:
- Rx, Tx lines (Nissan Consult I NC1, BlueTooth and USB adapters are supported).
- K-line (Nissan Consult II NC2, supports BlueTooth ELM327 adapters and USB K-line adapters - VAG COM KKL 409.1)

ECUs that are diagnosed via CAN bus (Nissan Consult III), as well as all diesel ECUs are NOT SUPPORTED!

Also for Nissan cars, CVTs via the Rx, Tx lines are supported - these are mainly RE0F06A / V CVTs that were installed between 1997 and 2006.

The program supports Toyota vehicles with K-line diagnostics via ELM327 adapter. At the moment, support is experimental...

The following operating modes are available for all control units:
- data reading mode, including recording logs and viewing them in graphical form.
-board (trip) computer mode
-active test mode (allows you to control actuators such as a fuel pump, coolant fan, etc.)
- read and reset errors

For the Nissan Consult II protocol, additionally available:
- correction of ignition timing and idle speed.
- learning the closed position of the throttle valve, learning the air supply when working at idle, resetting fuel adaptations.

For CVTs, the function of changing the intensity of engine braking is available.