BlueCArd
ID: com.nenoff.ardbttest
-
Versi: kapan:
Varies with device
-
Perbarui pada:
2020-05-21
Unduh APK sekarang
Garansi pemasangan aman, tidak ada iklan tambahan atau malware
Deskripsi dari BlueCArd
BlueCArd is a fully 3D printed open source indoor RC car. The brain of the card is an Arduino Nano compatible micro-controller and remote controlled through Bluetooth Low Energy (BLE).
My aim building this car was to make it very easy to build and as cheap as possible. That is why the car uses only standard elements and a mobile phone as a remote control.
The fine location permission is needed to search for Bluetooth devices. Without this permission the RC car can't be found!
The source code of this app and the Arduino sketch can be downloaded from github:
https://github.com/nenovmy/ardcar/
A detailed list of all needed elements can be found here:
https://www.thinker-talk.com/post/bluecard-3d-printed-arduino-rc-car-part-1
And all 3D printable elements can be downloaded from thingiverse:
https://www.thingiverse.com/thing:4332095
Build your own RC car today, have fun and write your experience in the comments!
My aim building this car was to make it very easy to build and as cheap as possible. That is why the car uses only standard elements and a mobile phone as a remote control.
The fine location permission is needed to search for Bluetooth devices. Without this permission the RC car can't be found!
The source code of this app and the Arduino sketch can be downloaded from github:
https://github.com/nenovmy/ardcar/
A detailed list of all needed elements can be found here:
https://www.thinker-talk.com/post/bluecard-3d-printed-arduino-rc-car-part-1
And all 3D printable elements can be downloaded from thingiverse:
https://www.thingiverse.com/thing:4332095
Build your own RC car today, have fun and write your experience in the comments!
Menampilkan lebih banyak
BlueCArd Varies with device APK untuk Android Varies with device+
Versi: kapan | Varies with device untuk Android Varies with device+ |
Perbarui pada | 2020-05-21 |
Menginstal | 50++ |
Ukuran file | 196.608 bytes |
Izin | izin lihat |
Apa yang baru |
1. STATE pin not used anymore. Heartbeat signal used to detect connect / disconnect 2. END byte removed, command now consists of header and parameters. Header fields (3 bytes) : * START (0x1) * COMMAND * Num of parameters WARNING! This version is not compatible with older Arduino sketch. If you update the app you have to update the Arduino sketch also! |
Riwayat versi:
- 1. LATEST. BlueCArd Varies with device APK (2020-05-21, 192 KB)
- 2. BlueCArd 1.0 APK (2020-05-06, 1 MB)
Menampilkan lebih banyak
Mirip dengan "BlueCArd"
Tekan APK
Menampilkan lebih banyak