BlueCArd
ID: com.nenoff.ardbttest
-
Phiên bản:
Varies with device
-
Cập nhật:
2020-05-21
Tải file APK ngay
Đảm bảo cài đặt an toàn, không thêm quảng cáo hay phần mềm độc hại
Mô tả của BlueCArd
BlueCArd is a fully 3D printed open source indoor RC car. The brain of the card is an Arduino Nano compatible micro-controller and remote controlled through Bluetooth Low Energy (BLE).
My aim building this car was to make it very easy to build and as cheap as possible. That is why the car uses only standard elements and a mobile phone as a remote control.
The fine location permission is needed to search for Bluetooth devices. Without this permission the RC car can't be found!
The source code of this app and the Arduino sketch can be downloaded from github:
https://github.com/nenovmy/ardcar/
A detailed list of all needed elements can be found here:
https://www.thinker-talk.com/post/bluecard-3d-printed-arduino-rc-car-part-1
And all 3D printable elements can be downloaded from thingiverse:
https://www.thingiverse.com/thing:4332095
Build your own RC car today, have fun and write your experience in the comments!
My aim building this car was to make it very easy to build and as cheap as possible. That is why the car uses only standard elements and a mobile phone as a remote control.
The fine location permission is needed to search for Bluetooth devices. Without this permission the RC car can't be found!
The source code of this app and the Arduino sketch can be downloaded from github:
https://github.com/nenovmy/ardcar/
A detailed list of all needed elements can be found here:
https://www.thinker-talk.com/post/bluecard-3d-printed-arduino-rc-car-part-1
And all 3D printable elements can be downloaded from thingiverse:
https://www.thingiverse.com/thing:4332095
Build your own RC car today, have fun and write your experience in the comments!
Xem thêm
BlueCArd Varies with device APK cho Android Varies with device+
Phiên bản | Varies with device cho Android Varies with device+ |
Cập nhật | 2020-05-21 |
Lượt tải | 50++ |
Kích thước tập tin | 196.608 bytes |
Quyền | xem các quyền |
Cập nhật mới |
1. STATE pin not used anymore. Heartbeat signal used to detect connect / disconnect 2. END byte removed, command now consists of header and parameters. Header fields (3 bytes) : * START (0x1) * COMMAND * Num of parameters WARNING! This version is not compatible with older Arduino sketch. If you update the app you have to update the Arduino sketch also! |
Phiên bản cũ hơn:
- 1. LATEST. BlueCArd Varies with device APK (2020-05-21, 192 KB)
- 2. BlueCArd 1.0 APK (2020-05-06, 1 MB)
Xem thêm
Tương tự "BlueCArd"
Được yêu thích
Xem thêm